Sidel SBO 10 Replacement: The Universal Infrared Heating Lamp We Built to Save Your Sanity
We built this replacement lamp for one simple reason: to stop the madness of hunting down OEM-specific parts. The Sidel SBO 10 is a workhorse, and its heating lamp is the heartbeat of the PET blowing cycle. When that lamp goes, your whole line stops. So we made a direct, drop-in replacement that crosses brand lines and fits over 95% of blowing equipment worldwide.
Power, Voltage, and Size—The Stuff That Actually Matters
Let’s get into the guts of it. We run a high-voltage, high-wattage setup—usually 400V at 2500W—packed into a 300mm quartz tube. That isn’t overkill. It’s exactly what it takes to heat PET preforms fast enough to keep cycle times tight. And the 300mm length? It’s a precise match for the SBO 10 reflector. Too short, and you get cold spots. Too long, and it won’t seat properly. We spec the lamp to hit the exact thermal zone needed so bottle wall thickness stays consistent. A 400V, 2500W tube throws down serious heat density, so make sure your machine’s cooling is up to the job.
Halogen, Quartz, and a Connector That Won’t Let You Down
Inside the tube, a halogen capsule runs hot—really hot. That’s why we use a high-purity quartz envelope. It handles thermal shock and stays clear, without degrading. The halogen cycle keeps the filament stable, so the lamp resists blackening and keeps its output for thousands of hours. Then there’s the R7s connector. It’s the mechanical anchor. It handles the amps and locks the lamp in tight. No wobble. No arcing. No premature failure. These lamps are built to take the vibration and thermal cycling of a busy production floor, day after day.
What It Does on the Line—And Why You’ll Feel the Difference
On the blow molding line, this lamp has one job: deliver concentrated infrared energy right where it’s needed—on the preform surface. The halogen design hits the right spectrum for fast, even heating. That means shorter cycle times and less scrap. For you, the engineer, that translates into fewer changeovers and less downtime. And because it’s universal, you can standardize your spares. We keep stock on the shelf, so you can wire it in and get back to production—immediately. This lamp was built for the realities of the plant floor. A tough, spec-matched component that keeps your PET line running.